Configuration
[MEET] Panel Tamper Alarm
The MEET system panels feature a tamper-proof safety push-button located on the rear. Operation Once the panel is powered up, pressing this button causes the unit to immediately emit a high-intensity audible alarm, designed to alert the owners to any ...
[MEET KIT] If you have more than one street panel
To activate the additional panels, we need to check the following points: The street panels and monitors installed must be on the same physical network and have the same IP address. All panels will be configured as 1W PANEL, and both the monitor(s) ...
How to wire the proximity reader integrated into the MEET building panel to an EXTERNAL CONTROLLER.
The connection would be as follows: 1. Power the EXTERNAL controller (with Wiegand 26 input) with an external 12 Vdc 4813 power supply. 2. Remove the –(NEGATIVE) WD0 and WD1. The negative will be connected to the negative power input of the EXTERNAL ...
Why am I not receiving the guest codes to my Access Controller?
It is very important to pay attention to the cable connection of the guest module ref. 1494 of the wiegand part that arrives at the controller, as the colour code of the molex included can lead to confusion. According to the attached image the wiring ...
[MEET] KIN 1L panel settings to call the concierge.
In this guide we will find the settings that must be configured in the KIN panel to call exclusively to a concierge desk and making a call as a KIN 1L panel. Remember that the IP's of the devices must be previously configured, they must have internet ...
How to add users with Face Recognition on MEET badges?
[MEET] FACE RECOGNITION In all our series of MEET panels (Marine, Kin and Milo) we have the face recognition function to control access to our installation, providing greater comfort to our users. CAPABILITIES: UP TO 6000 USERS. 6000 USER ...