General
[MEET] Abnormal behaviour in MEET devices caused by the SIP ALG parameter
In a Fermax MEET system, the SIP ALG (Application Layer Gateway) parameter on some routers and firewalls can cause abnormal behaviour because it attempts to automatically modify SIP packets to facilitate VoIP telephony. However, MEET already ...
[MEET] Case study: MEET residential complex estate with IP video door entry system
For a MEET installation in a gated community, comprising: A digital panel at the main entrance to the site. Fenced detached houses. A dedicated access panel on each plot. The recommended architecture is as follows: Operation Main entrance to the ...
[MEET] Installations with distances greater than 100 metres between devices
When there are distances greater than 100 meters between devices in your MEET Kit ref 1506, 1507, or 1508, the following steps must be followed: Check that it is installed as shown in the image and that the recommended distances between the switch ...
[MEET KIT] Start-up and configuration with the MeetMe app
To start up the MEET Kit ref. 1506, 1507 or 1508, follow these steps: Check that it is installed as shown in the image and that the recommended distances between the switch and the devices are not exceeded If the installation is wired as shown in the ...
[MEET] Start-up of board with license 1496, without MEET monitor
To configure your door panel to make calls to your smartphone, make sure it meets the following requirements. You must have two licences, one must be stuck to the back of the MEET panel and the other must be (ref. 1496 MEET ME CALL DIVERT LICENSE ...