[MEET] Start-up of board with license 1496, without MEET monitor

[MEET] Start-up of board with license 1496, without MEET monitor

To configure your door panel to make calls to your smartphone, make sure it meets the following requirements.

  • You must have two licences, one must be stuck to the back of the MEET panel and the other must be (ref. 1496 MEET ME CALL DIVERT LICENSE WITHOUT TERM 1 APART | FERMAX)
  • The panel must have an internet connection with an upload speed of more than 3 Mbps.
  • If the panel is connected to a 4G router, we recommend configuring the call forwarding via TLS. This configuration can be done from V3.6 onwards.

How to configure the street panel:

  1. In the GENERAL menu, configure the panel as shown in the image.                                                                                                    
  2. Put the panel in the router's network range. You can watch the following video until minute 3:50                                                                                        
  3. Configure the SIP menu with the licence that comes attached to the panel. It can be configured by UDP (left image) or by TLS if there is a 4G router as in the image on the right. Remember to set the SIP server to sip:sip.fermax.com:4443
  1. The next step is to configure the additional license ref 1496 on the board. To do this, go to the SIP CALL menu:                                         
    1. In the APARTMENT box, enter the number configured in APARTMENT in the general menu.                                             
    2. In the number box, enter the address 'sip:(licenciaref1496_user)@sip.fermax.com'
    3. Remember that the call will only work if the panel is correctly registered with the street board license. As shown in the image, REGISTERED should appear in green when you click on VIEW SIP STATUS.                             



    • Related Articles

    • [MEET KIT] If you have more than one street panel

      To activate the additional panels, we need to check the following points: The street panels and monitors installed must be on the same physical network and have the same IP address. All panels will be configured as 1W PANEL, and both the monitor(s) ...

    • How to add users with Face Recognition on MEET badges?

      [MEET] FACE RECOGNITION In all our series of MEET panels (Marine, Kin and Milo) we have the face recognition function to control access to our installation, providing greater comfort to our users. CAPABILITIES:    UP TO 6000 USERS. 6000 USER ...

    • [MEET KIT] Start-up and configuration with the MeetMe app

      To start up the MEET Kit ref. 1506, 1507 or 1508, follow these steps: Check that it is installed as shown in the image and that the recommended distances between the switch and the devices are not exceeded If the installation is wired as shown in the ...

    • [MEET] If you do not receive a call from the monitor

      To resolve the issue, we need to check the following points: The panel and monitor(s) must be connected to the same router and the IP addresses assigned to them must be within the router's address range. If the panel is configured as a block panel, ...

    • [MEET] Connection for door lock

      To open the door from your MEET Kit ref. 1506, 1507, or 1508, you have a potential-free contact to open the door depending on the type of door: Door with a latch that has an electric door opener on the frame. There are different formats and they can ...


    MANUALS
    Find manuals, technical books, tender specifications and much more on our professional website.

       
      INTERNATIONAL DISTRIBUTORS
      Fermax International Distribution Network.