There is a device: lights and ringtone activator ref. 2438 that is used for this. This device can be used in installations that require high voltages when receiving a call. This equipment may activate a ringtone, a siren or light when the street ...
The MDS/VDS decoder is a device that carries out the conversion of the MDS system from the general input point to the VDS system in the interior blocks. One MDS/VDS decoder is necessary per block. The MDS/VDS decoder can manage 1 to 199 homes per ...
Yes, Fermax outdoor panels that have pushbuttons can be identified using Braille. To do so, there are special adhesives that are very resistant and suitable for all kinds of weather. They are fixed to the exterior to allow tactile reading for the ...
* The Central Unit allows you to manage complex door-entry and MDS video door-entry installations combined with access control. * Each Central unit can manage up to 10000 homes, 1022 users and up to 32 street door entry, video door entry, guard units ...
The firmware developed in each of these is different and therefore the software used for managing it as well: Central Unit with version V4.x uses WINCOM. Central Unit with version V5.x uses WINCOM+ software.Notice: Central Units V5.x or greater are ...
In two entrance video entry installations you need to use a VDS switcher ref. 2450. It is not necessary in systems in which one of the accesses is audio only. Its purpose is to select the video signal of the panel from which the call has been made. ...
The functions available on the Smile VDS Basic Monitor are summarised in the following list: It has capacitive buttons. Open door. Call to guard. Call Volume Regulation. Call disconnection (Do not Disturb). Ringtone Selection (5 options). Doorbell. ...