What is a Central Unit ref. 2405 and what is it used for?
* The Central Unit allows you to manage complex door-entry and MDS video door-entry installations combined with access control.
* Each Central unit can manage up to 10000 homes, 1022 users and up to 32 street door entry, video door entry, guard units or access controls.
* You can connect up to 63 central units in a FXL network. In this case only 31 panels can be connected per Central Unit.
* It incorporates the WinCom+ Management Software.
* With the capacity to manage 1000 intercommunication panels, 1000 sensors and 1000 relays.
* Local connection (USB, RS-232) or remote (IP) to the PC via the corresponding module (see accessories).
Technical Characteristics:
- 1022 users.
- 32/31 entrances depending on the system.
- Recording of the last 3,000 incidents (entries, exits, accesses denied, alerts, etc.) in memory, without needing to download the PC.
-
With the option of connecting the readers with an integrated controller
and without an integrated controller (via the door controller).
Programming
All programming is done with the Wincom+ software.Related Articles
Is there any difference between the MDS Central Units (ref. 2405 with version V4.x and V5.x (or greater)?
The firmware developed in each of these is different and therefore the software used for managing it as well: Central Unit with version V4.x uses WINCOM. Central Unit with version V5.x uses WINCOM+ software.Notice: Central Units V5.x or greater are ...What steps must I take to start up the Cityline Proximity Reader (configured as autonomous) ref. 6992 or Marine Proximity Reader (configured as autonomous) ref. 5472 or Skyline Proximity (configured as autonomous) ref. 7440?
To use personal proximity cards, the private proximity card reader must be activated. To activate the reader the MASTER card must be programmed. This is the card which is subsequently used to access the programming functions. Once the reader is ...What is a MDS/VDS Decoder ref. 2409?
The MDS/VDS decoder is a device that carries out the conversion of the MDS system from the general input point to the VDS system in the interior blocks. One MDS/VDS decoder is necessary per block. The MDS/VDS decoder can manage 1 to 199 homes per ...What can be programmed in a VDS switcher ref. 2450 and what is it for?
In two entrance video entry installations you need to use a VDS switcher ref. 2450. It is not necessary in systems in which one of the accesses is audio only. Its purpose is to select the video signal of the panel from which the call has been made. ...Is there a device that can activate a ringtone or light at 220Vac or that turns a light on with the call to guard/video entry-system in a VDS system?
There is a device: lights and ringtone activator ref. 2438 that is used for this. This device can be used in installations that require high voltages when receiving a call. This equipment may activate a ringtone, a siren or light when the street ...