What steps must I take to start up the Cityline Proximity Reader (configured as autonomous) ref. 6992 or Marine Proximity Reader (configured as autonomous) ref. 5472 or Skyline Proximity (configured as autonomous) ref. 7440?
To use personal proximity cards, the private proximity card reader must be activated.
- To activate the reader the MASTER card must be programmed. This is the card which is subsequently used to access the programming functions.
- Once the reader is installed, the system will take the first card swiped after powering up the system to be the MASTER card.
- Activating Personal Cards
- 3.1. Swipe the MASTER card. The indicators show the user is in "Card Activation Mode (indicator + lit)".
- 3.2 Swipe the card(s) you wish to activate, one by one. Write down each card´s code in a safe place for future reference.
Notes:
- One "beep" indicates that the card has been set up correctly. Otherwise a double beep will indicate that it was already active or that the card is defective.
- If you attempt to activate more than 400 cards the system will indicate "overload" (the "+" indicator will flash for 5 seconds).
- 3.3 Swipe the MASTER card again once finished, until the indicators show "Normal Mode" status (lock indicator on).
- Adjusting the Door Opening Time
- 4.1. Swipe the MASTER card (three times). The indicators show we are in "Lock-Release Activation Time Configuration Mode (Door indicator + on".
- 4.2 Swipe any card (except the MASTER card) once for every second you want the lock-release to be activated for. Once: 1 second, Twice: 2 seconds, Thrice: 3 seconds.
- 4.3 Swipe the MASTER card again once finished, until the indicators show "Normal Mode" status (lock indicator on).
All steps are explained in the manual.Related Articles
How do you program the Cityline Proximity Reader (configured as autonomous) ref. 6992 or Skyline Proximity Reader (configured as autonomous) ref. 7440 or Private CityClassic ref. 2347 or Private Loft ref. 4530 or Marine Proximity Reader (configured as autonomous) ref. 5472?
Programming may be done 3 different ways. Master Card: The first time you connect the power, the system waits for the proximity card to be presented and considered as “Master Card”. Private Programming Keypad ref. 2306: This MANUAL programming ...How do you replace a master card if you lose or change the previous one in a Cityline Proximity Reader (configured as autonomous) ref. 6992 or Marine Proximity Reader (configured as autonomous) ref. 5472 or Skyline Proximity (configured as autonomous) ref. 7440?
This operation is carried out by electrically modifying the equipment, with the aim of restricting anyone without physical access to the equipment from modifying it in any way. Steps: 1. Disconnect the power supply. 2. Press the open door button from ...What is a Skyline Proximity Reader ref. 7440 and what are its general characteristics?
This is an autonomous or centralized access control reader that allows for the opening via a proximity card or key ring. This proximity reader via the configuration of its dipswitches (SW2), may work in autonomous or centralised access control ...[DESFIRE] Proximity reader DESFIRE NOT compatible with EM Programming Keypad ref. 2306
As a result of an incident we have detected that we have an error in the manual of the DESFIRE 7463 proximity reader, in the autonomous manual code 970206 V01_21 as it indicates that it is compatible with the programming keyboard REF. 2306 and it is ...[AC-MAX] What maximum distance can I have between the furthest reader and the controller if it is fingerprint or wiegand?
If the reader is an AC-MAX fingerprint reader ref. 5225 this reader is connected to the controller by RS-485, therefore up to 1200m, but additionally, it must be considered that it is also connected by Ethernet, therefore it will have to have a ...