[AC-MAX] How to change the IP address of the control panel using the control panel's own MICROSD card.
1. Disconnect the power supply.
2. Apply slight pressure to the MicroSD card to remove it.
3. Insert it into the PC using an adapter and change the IP address to the same IP address as the control panel to be changed, which can be seen in the AC-MAX software.
In this example, the control panel had the IP address 192.168.1.213.
When inserting the MicroSD card, we see that it has the address 192.168.0.213.
So we must modify the IP file with Notepad. Change the IP address and save.
Cambiar la ip y guardar
Carefully reinsert the MicroSD card into the control panel with the power off and turn the power back on.
Wait for the LEDs to settle, with LED 1 steady and LED 8 flashing.
Once you have the correct IP address, ping the control panel to see if it is detected on your network.
Go to Windows and type cmd.
Run and enter ping 192.168.x.x, the IP address you want to check.
If you receive a response, you are ready to proceed.
Related Articles
[AC-MAX] Integration of license plate recognition in AC-MAX.
AC-MAX allows us to open barriers by means of license plate recognition. For integration it is necessary to install special IP cameras with local license plate recognition and wiegand-26 output with SHA-1 protocol. The wiegand output of the camera is ...[AC-MAX] How to replace the expander on a control panel if it has broken down.
1. Disconnect the power supply to the controller to be repaired. 2. Remove the connection strip(s) from the faulty unit. As it is a DIN rail, press down with a flat screwdriver on the white tab so that the entire circuit comes out once the connection ...[AC-MAX] 5223 5224 Reset factory defaults AC-MAX 2/4-door kits
For point 7 1º Install AC-MAX HW 2º Connect to the control panel normally v1.7 without password (without the communication key, as it will no longer have a password when reset). 3º From Tools - establish the communication key 1234, 1234 and check. 4º ...[AC-MAX] How to replace a faulty controller in AC-MAX
1. Run AC-MAX CS to check that the communication service is active. If it is not recognised, go to the communication server, delete the current address and detect it. When the server is detected, select it. Then run a test to check that everything is ...[AC-MAX] Differences between the RED and BLACK user clear icons in AC-MAX LT and AC-MAX ST software.
In AC-MAX LT entering the user panel. I can delete the users with two types of DELETE icon, one red and one black. When deleting in red we can move the cards to the card store but the fingerprint will remain in the database and will not allow us to ...
Find manuals, technical books, tender specifications and much more on our professional website.