[AC-MAX] 5223 5224 I can't synchronise the control unit and I get the following error.

Error that appears in the synchronisation when the little arrow at the bottom right is displayed.

Processing configuration: Error Most likely, changes to the low-level controller configuration have been detected. Please try to run the controller discovery process.

This indicates that low-level changes have been made and the controller needs to be re-initialised/discovered.

So we will go with the mouse over the controller and with right button we will go to Commands-Execute device initialisation.

Finally synchronise again.

• Related Articles

• [AC-MAX] Are CCTV RTSP cameras supported on AC-MAX?

  Yes, from the version of AC-MAX V2.0. In version V1.6.2, RTSP cameras are not compatible. The following table specifies the compatible models.

• [AC-MAX] 5223-5224 Do I need a 4420 ACPLUS door controller to connect a wiegand reader to AC-MAX kit?

  Not since the 4420 is exclusive to the ACPlus system and is not compatible with AC-MAX. In addition, AC-MAX allows the direct connection of the wiegand readers up to 4 readers per control unit with 2 or 4 doors.

• [AC-MAX] 5223 5224 Incompatibility between controller versions V.1.7.2.562 and V.1.7.2.604.

  This does not occur in new construction as central controllers are not mixed. It only happens if we have to replace a defective controller or extend an existing installation with V.1.7.2.562 controllers. We have to take the following into account: ...

• [AC-MAX] 5223 5224 Reset factory defaults AC-MAX 2/4-door kits

  For point 7 1º Install AC-MAX HW 2º Connect to the control panel normally v1.7 without password (without the communication key, as it will no longer have a password when reset). 3º From Tools - establish the communication key 1234, 1234 and check. 4º ...

• [AC-MAX] ¿[AC-MAX] Can we also offer the switches to connect the control panels and fingerprint readers to the ethernet network?

  Yes, Fermax has the references 1586 IP SWITCH 4 PoE PORTS and 1587 IP SWITCH 8 PoE PORTS. One socket or port must be counted for each existing control unit and each 5225 fingerprint reader that we have in the installation.

MANUALS

Find manuals, technical books, tender specifications and much more on our professional website.

 

INTERNATIONAL DISTRIBUTORS

Fermax International Distribution Network.